Housing for StreetPilot 26xx

Housing for 26xx is designed for installation on crossbar of GadgetGuy bracket kits as well as for installation on the crossbar of enduro and off road type of handlebars. The clamping diameter is 0.5".
There are two finishes available: anodized black as shown above (
1) and plain aluminum as shown below (1).
Housings can also be assembled as "non-detachable" (
3) and "detachable" (5). Some times desirable location of the housing does not allow it to be opened completely (3). There fore it is impossible to insert or remove GPS unit in or out of housing. In that cases detachable assembly is recommended (5). It allows to open the housing just to clear the lock (3) and slide it off the pivoting pins (4). That way the housing will come completely apart (5) allowing easy incretion and removal of GPS unit.
Conversion of non-detachable assembly in to detachable is very simple. Each pivoting pin has to be pressed further in to the back plate to clear the pivoting hole, but remain in the aligning cut outs (compare
2 and 2). Engaging pivoting pin in to pivoting holes converts assembly back in to non-detachable.

Back to Catalog Page 12
Back to Catalog Page 12
Back to Catalog Page 12
Back to Catalog Page 12